How to Read Your Electricity Bill
Most of a home electricity bill comes down to one subtraction and one slab table. Here is what every other line means, and how to check the total yourself.
The number that decides most of your bill sits in two boxes: the previous meter reading and the current one. Subtract the first from the second and you have the units you are being charged for. Everything else on the page is either a rate applied to those units, a fixed amount, or an adjustment from an earlier bill.
Layouts differ between DISCOMs, and the same charge can go by three different names in three states. The order below follows how a bill is built, not how it is printed, so you may have to hunt for some lines.
The top of the bill: your connection details
Before the money, check that the bill is describing your connection correctly. These lines rarely change, but when they are wrong every later number is wrong too.
| Line on the bill | What it means |
|---|---|
| Consumer number / account ID / CA number | Your connection's ID. You need it for payments and complaints. |
| Tariff category | Which rate table applies, such as LT domestic. A home billed under a commercial category pays more. |
| Sanctioned or contracted load (kW) | The maximum load you applied for. Some tariffs charge the fixed charge per kW of this figure. |
| Meter number and phase | Lets you confirm the reading came from your meter, and whether you have single-phase or three-phase supply. |
| Bill period and reading dates | One month or two. Two-month bills use doubled slab limits. |
Meter readings and units
Units consumed = current reading − previous reading. A few bills show a multiplying factor (MF) as well; for a normal home meter it is 1. If your bill shows 14,382 and 14,628, you used 246 units, and one unit is one kilowatt-hour (kWh): a 1,000 W heater running for an hour, or a 9 W LED bulb running for about 111 hours.
Look for the reading status next to the current reading. If the meter reader could not get access, or the meter was faulty, the DISCOM may bill an average or estimated figure instead of a real reading. The words or codes vary ("estimated", "average", "door locked", "RNA"), but any of them means the units are a guess. The next actual reading corrects it, which is why a low estimated bill is often followed by a high one. Taking a dated photo of your meter each month is the easiest way to check.
The charges, in the order they are worked out
Energy charges
Units multiplied by the slab rates in your tariff. In a telescopic tariff the first block of units is charged at the lowest rate, the next block at the next rate, and so on. Bills that list the slabs separately make this easy to check; others show only the total.
Fixed or demand charge
A flat monthly amount for being connected, either per connection or per kW of sanctioned load. You pay it even in a month you use nothing.
Fuel and power purchase adjustment
Names include FPPCA, FAC, FPPAS and "fuel surcharge". When the DISCOM's cost of buying power differs from what the tariff assumed, the regulator lets it pass the difference on as a few paise per unit, up or down. It can change from month to month.
Electricity duty and other levies
A state tax, usually a percentage of energy charges and sometimes of the fixed charge too. A few states charge a fixed amount per unit instead. Some bills also carry a small cess or a municipal tax line.
Meter rent, subsidy and rebates
Meter rent appears if the meter belongs to the DISCOM and your state charges for it. A state subsidy or free-units scheme shows as a deduction, sometimes labelled "government support" or "subsidy". Rebates for paying early or online are deducted only if you pay that way before the stated date.
Arrears, interest and surcharge
Unpaid amounts from earlier bills are carried forward as arrears. A late payment surcharge is added if the last bill was paid after its due date. Interest on your security deposit, when it is credited, appears as a deduction.
A sample bill, checked line by line
Here is a one-month bill for 246 units on an example tariff (not any real state's): ₹3 a unit up to 100 units, ₹4.50 for 101–200, ₹6 for 201–300 and ₹7.50 above that, a ₹75 fixed charge, a fuel adjustment of 30 paise a unit and 5% duty on energy charges.
| Line | Working | Amount |
|---|---|---|
| Energy, slab 1 | 100 units × ₹3 | ₹300.00 |
| Energy, slab 2 | 100 units × ₹4.50 | ₹450.00 |
| Energy, slab 3 | 46 units × ₹6 | ₹276.00 |
| Fixed charge | one month | ₹75.00 |
| Fuel adjustment | 246 × ₹0.30 | ₹73.80 |
| Electricity duty | 5% of ₹1,026 | ₹51.30 |
| Total | ₹1,226.10 |
That works out to about ₹4.98 a unit on average. If the same state charged duty on the fixed charge and fuel adjustment as well, the duty line would be ₹58.74 and the total ₹1,233.54. That kind of small difference is usually what stops a home calculation from matching the bill exactly, so it helps to know which base your state uses.
The average hides the more useful number. Unit 247 would fall in the ₹6 slab, cost 30 paise of fuel adjustment and attract duty on the ₹6, so it adds ₹6.60. Cutting usage saves at that rate, not at ₹4.98. You can reproduce all of this, with your own tariff, in the electricity bill calculator.
Two-month bills
Where billing is every two months, the slab limits are doubled. A 492-unit, two-month bill on the example tariff charges the first 200 units at ₹3, the next 200 at ₹4.50 and the last 92 at ₹6, giving energy charges of ₹2,052, exactly twice the 246-unit monthly figure. The fixed charge is also for two months. If a two-month bill seems to jump a slab, check that the DISCOM applied doubled limits; it should be printed with the tariff details.
When the bill looks wrong
Most surprises have ordinary causes, so rule these out first, roughly in this order:
- Compare the current reading on the bill with the meter itself, or with your photo from the reading date.
- Look for an "estimated" or "average" status on this bill or the previous one.
- Check the category, the sanctioned load and the billing period.
- Compare with the same month last year rather than last month. Summer bills on the example tariff run well above winter ones even in a careful home: 210 units cost ₹988.50 there, and 300 units ₹1,582.50.
- Look for arrears, a late payment surcharge or an additional security deposit that may not belong.
If something is still wrong, complain to the DISCOM in writing (most have an online form and a helpline) and keep the complaint number. Every DISCOM must have a Consumer Grievance Redressal Forum under the Electricity Act, 2003, and if the forum does not resolve your complaint you can go to the state Electricity Ombudsman. The Electricity (Rights of Consumers) Rules, 2020 set out what you are entitled to, including accurate billing. Your bill or the DISCOM's website lists the forum's address.
If the units are right and simply high, the next step is finding where they go. The appliance cost calculator ranks your appliances by units, and the guide to reducing your bill works through the biggest savings one appliance at a time.
Frequently asked questions
Can I ask for my meter to be tested?
Yes. DISCOMs test meters on request when a consumer disputes the readings, usually for a fee that is refunded if the meter turns out to be faulty. Ask at your section office or through the DISCOM's complaint system, and keep a dated photo of the meter display.
Why did my security deposit go up?
Many DISCOMs review the security deposit once a year against your average bill. If you now use more electricity, they may bill an additional security deposit, often shown as ACD. It is still your money and earns interest, which is credited on a later bill.
My bill shows the right units but a higher category. What should I do?
Check the tariff category and sanctioned load printed near the top. A home billed as commercial, or with a load far above what you applied for, pays more for every unit and in fixed charges. Raise it with the DISCOM in writing, with a copy of your connection papers.